Leider War nichts mehr zu retten. Habe die Platte neu formatiert.
Beigefügt das Smartcontrol Protokoll. Was meint Ihr ? Platte in die Tonne ?
linux-z5na:~ # smartctl -a /dev/sdc
smartctl 6.2 2013-07-26 r3841 [i686-linux-3.12.53-40-default] (SUSE RPM)
Copyright (C) 2002-13, Bruce Allen, Christian Franke,
http://www.smartmontools.org
=== START OF INFORMATION SECTION ===
Model Family: Seagate Pipeline HD 5900.2
Device Model: ST31000322CS
Serial Number: 9VX0RFK2
LU WWN Device Id: 5 000c50 0206859ea
Firmware Version: SC13
User Capacity: 1,000,204,886,016 bytes [1.00 TB]
Sector Size: 512 bytes logical/physical
Rotation Rate: 5900 rpm
Device is: In smartctl database [for details use: -P show]
ATA Version is: ATA8-ACS T13/1699-D revision 4
SATA Version is: SATA 2.6, 3.0 Gb/s (current: 1.5 Gb/s)
Local Time is: Thu Mar 31 18:44:35 2016 CEST
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
See vendor-specific Attribute list for marginal Attributes.
General SMART Values:
Offline data collection status: (0x00) Offline data collection activity
was never started.
Auto Offline Data Collection: Disabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 623) seconds.
Offline data collection
capabilities: (0x73) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
No Offline surface scan supported.
Self-test supported.
Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 1) minutes.
Extended self-test routine
recommended polling time: ( 220) minutes.
Conveyance self-test routine
recommended polling time: ( 2) minutes.
SCT capabilities: (0x103b) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 10
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000f 103 096 006 Pre-fail Always - 5250256
3 Spin_Up_Time 0x0003 096 093 000 Pre-fail Always - 0
4 Start_Stop_Count 0x0032 092 092 020 Old_age Always - 9028
5 Reallocated_Sector_Ct 0x0033 100 100 036 Pre-fail Always - 0
7 Seek_Error_Rate 0x000f 081 060 030 Pre-fail Always - 158149962
9 Power_On_Hours 0x0032 093 093 000 Old_age Always - 6891
10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 096 096 020 Old_age Always - 4498
184 End-to-End_Error 0x0032 100 100 099 Old_age Always - 0
187 Reported_Uncorrect 0x0032 022 022 000 Old_age Always - 78
188 Command_Timeout 0x0032 100 001 000 Old_age Always - 7143617
189 High_Fly_Writes 0x003a 062 062 000 Old_age Always - 38
190 Airflow_Temperature_Cel 0x0022 068 043 045 Old_age Always In_the_past 32 (0 164 32 26 0)
194 Temperature_Celsius 0x0022 032 057 000 Old_age Always - 32 (0 18 0 0 0)
195 Hardware_ECC_Recovered 0x001a 046 038 000 Old_age Always - 5250256
197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 0
198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 0
199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 0
SMART Error Log Version: 1
ATA Error Count: 80 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 80 occurred at disk power-on lifetime: 6890 hours (287 days + 2 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 8e 92 43 00 Error: UNC at LBA = 0x0043928e = 4428430
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 80 3f 92 43 e0 00 00:01:50.408 READ DMA
ec 00 00 8e 92 43 a0 00 00:01:50.383 IDENTIFY DEVICE
c8 00 80 3f 92 43 e0 00 00:01:49.075 READ DMA
ec 00 00 8e 92 43 a0 00 00:01:49.051 IDENTIFY DEVICE
c8 00 80 3f 92 43 e0 00 00:01:47.753 READ DMA
Error 79 occurred at disk power-on lifetime: 6890 hours (287 days + 2 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 8e 92 43 00 Error: UNC at LBA = 0x0043928e = 4428430
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 80 3f 92 43 e0 00 00:01:49.075 READ DMA
ec 00 00 8e 92 43 a0 00 00:01:49.051 IDENTIFY DEVICE
c8 00 80 3f 92 43 e0 00 00:01:47.753 READ DMA
ec 00 00 8e 92 43 a0 00 00:01:47.728 IDENTIFY DEVICE
c8 00 80 3f 92 43 e0 00 00:01:46.430 READ DMA
Error 78 occurred at disk power-on lifetime: 6890 hours (287 days + 2 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 8e 92 43 00 Error: UNC at LBA = 0x0043928e = 4428430
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 80 3f 92 43 e0 00 00:01:47.753 READ DMA
ec 00 00 8e 92 43 a0 00 00:01:47.728 IDENTIFY DEVICE
c8 00 80 3f 92 43 e0 00 00:01:46.430 READ DMA
ec 00 00 8e 92 43 a0 00 00:01:46.406 IDENTIFY DEVICE
c8 00 80 3f 92 43 e0 00 00:01:45.077 READ DMA
Error 77 occurred at disk power-on lifetime: 6890 hours (287 days + 2 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 8e 92 43 00 Error: UNC at LBA = 0x0043928e = 4428430
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 80 3f 92 43 e0 00 00:01:46.430 READ DMA
ec 00 00 8e 92 43 a0 00 00:01:46.406 IDENTIFY DEVICE
c8 00 80 3f 92 43 e0 00 00:01:45.077 READ DMA
ec 00 00 8e 92 43 a0 00 00:01:45.053 IDENTIFY DEVICE
c8 00 80 3f 92 43 e0 00 00:01:43.769 READ DMA
Error 76 occurred at disk power-on lifetime: 6890 hours (287 days + 2 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 8e 92 43 00 Error: UNC at LBA = 0x0043928e = 4428430
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 80 3f 92 43 e0 00 00:01:45.077 READ DMA
ec 00 00 8e 92 43 a0 00 00:01:45.053 IDENTIFY DEVICE
c8 00 80 3f 92 43 e0 00 00:01:43.769 READ DMA
c8 00 80 bf 91 43 e0 00 00:01:43.758 READ DMA
25 00 20 ff ff ff ef 00 00:01:43.757 READ DMA EXT
SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Short offline Completed: read failure 90% 6886 4428430
# 2 Short offline Completed: read failure 90% 6886 4428430
# 3 Short offline Completed: read failure 90% 6886 4428430
# 4 Short offline Completed: read failure 90% 6886 4428430
# 5 Short offline Completed: read failure 90% 6885 4428430
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.
linux-z5na:~ #