cams in tf6060 CI - can anyone help out?

[mallanikkelsen]

Hello everyone

At the moment I am using two cams in my tf6060 CI receiver. The first cam is the alphacrypt cam, withwhich I decode the premiere channels, and the other is an Astoncrypt 1.07 cam used for the frensh canal+ channels.
However, I am experiencing something very strange when watching and changing channels, and I was wondering if anyone inhere have had the same problem? If yes, I'd be very greatful for suggestions as to how the problems can be saulved.

all the premiere channels work perfectlly in the alphacrypt cam. The only thing that is a little annoying is that the moddule is very very slow when it comes to changing channels. It Often takes more than 10 secunds to go from one premiere channel to another. however, when the channel finally decodes, I can watch it without further problems. Any ideas as to what can cause this slow channel changing?

It is however, alot worse with the astoncrypt and the canal+ channels. First off, the changing of the channels is also very very slow on this cam, perhaps slower then with the alphacrypt. Furthermore, when the channels finally decodes, I am only able to watch for a few minutes, before sound and picture dissapeeres, only to return again a few seconds later. Well, it keeps doing this, untill I change to a channel which is not decoded by the moddule.

Any ideas as to what might cause these problems?

Kind regards from allan