TF5400 gets stuck every often
Verfasst: Sa 2. Jan 2010, 23:28
Hi,
Sorry that I write in English, but my German would be not understandable: wink:.
A few days since I am the proud owner of a TF5400 PVR: D:. It is the perfect device for me, but unfortunately, it does not seem to work well: (. If I watch 1 hour of satellite television, I have to switch to standby and power on again at least 3 times as the device gets completely blocked (picture freeze, no reaction to remote control) while just watching a channel.
Next to that, I am not so impressed by the DVB-T receiver sensitivity. The receiver seems to be less good than the cheap one (dedicated DVB-T receivers for 50 euro) I was using till now. With the same signal, the TF5400 has much more hick-ups than the old one (which basically has no hick-ups at all!)
I tried the latest firmware programming already available to the device, but that did not help at all The only thing I do not get is why the loader version (4.08) is much older than the rest of the versions and therefore not the most recent one (which appears to be 5.23). I noticed that the loader version is not changed if I download the lasted software into the device.
I would be very happy to know if any of you experienced the same or similar problems before or already know another solution to this problem than sending the device back to the shop ...
Thanks in advance,
Koen Vanhoof
Sorry that I write in English, but my German would be not understandable: wink:.
A few days since I am the proud owner of a TF5400 PVR: D:. It is the perfect device for me, but unfortunately, it does not seem to work well: (. If I watch 1 hour of satellite television, I have to switch to standby and power on again at least 3 times as the device gets completely blocked (picture freeze, no reaction to remote control) while just watching a channel.
Next to that, I am not so impressed by the DVB-T receiver sensitivity. The receiver seems to be less good than the cheap one (dedicated DVB-T receivers for 50 euro) I was using till now. With the same signal, the TF5400 has much more hick-ups than the old one (which basically has no hick-ups at all!)
I tried the latest firmware programming already available to the device, but that did not help at all The only thing I do not get is why the loader version (4.08) is much older than the rest of the versions and therefore not the most recent one (which appears to be 5.23). I noticed that the loader version is not changed if I download the lasted software into the device.
I would be very happy to know if any of you experienced the same or similar problems before or already know another solution to this problem than sending the device back to the shop ...
Thanks in advance,
Koen Vanhoof