BluField62 hat geschrieben:Moin,
bekomme die Namen für ausgehende Anrufe nicht in die Anzeige, eingehende schon
Was muss ich einstellen?
Im Fritzbox Tel Buch hab ich mal nen Eintrag gemacht, hat aber nichts genützt?!
Der Rest funktioniert mittlerweile.
Hätte gestern gut eure Hilfe gebrauchen können, das Forum ließ mich aber nicht rein
Hallo BluField62,
so funktioniert es bei mir
# Name of IP address of the fritz box
# FritzBox=192.168.178.1
FritzBox=fritz.box
# StartupConnectDelay is the Delay in seconds the TAP will wait after startup
# until a connection to the Fritz Box is made
StartupConnectDelay=30
# Position of Callmonitor Window
Xpos=30
Ypos=56
# Time the Callmonitor is displayed in seconds
# If set to 0 the Window will not be closed automatically, use exit to close it
# If set to -1 the message will not be shown
# DisplayDelay is for error messages
DisplayDelay=10
# IncomingDelay is for incoming call messages
# when set to 0 a connect or disconnect will close the window
IncomingDelay=0
# ConnectDelay is for connect messages
ConnectDelay=10
# CalloutDelay is for call out messages
CalloutDelay=10
# DisconnectDelay is for disconnect messages
# DisconnectDeley=-2 will not show the message and will also not close the Incoming Call message
DisconnectDelay=10
# Font color (R,G,B)
FontColor = 255,255,255
# 1 = Fritz Box Numbering, 0 = sequential line numbering starting with 1
FritzBoxLineNumbering = 0
# Areacode will enable local numbers to be found in the telephonebook, but is not needed
AreaCode=04126
# List your own numbers without area code here. All calls for this number will be shown
# All calls will be shown when empty or not set
#MSN=
# Decimal code of the key that will open the caller list or telephonebook
# Default is the Option key
ActionKey=16842811
ein- und ausgehender Anruf!# Address Book
# Usage: telephone number = Name
# Use the full number as can been seen in the call history of the Fritz box
# Only 128 Entries are supported at the moment
#
# Do NOT delete the following entry without a number. That is used for blocked numbers (CLIR)
= Unbekannte Anrufer (CLIP unterdrückt)
#
# The format is
# number = name, picture.jpg, Category
017312345678 = Name, name.jpg, Friends
015209123827 = Schulze (1und1), Schulze.jpg , Familie
01707302340 = Rössner (T-Mobile), Roesner.jpg, Familie
04126234 = Meyer
LG
Der Olaf
:
ops: 
